Team Associated RC10 B5m Mid-Motor & Rear Motor Thread
|
|||
#3512
Tech Adept
#3513
I did lose a left front wheel when my blue loc-tited axle screw came apart on the second battery. Assumed it was a bad design like the TLR22 front wheel bolt that does the same thing till you have blue loc-tite'd it a few times (one isn't enough on either). I'll have to check this every battery pack I guess No kit is perfect and that screw is really short.
#3514
Tech Elite
I did lose a left front wheel when my blue loc-tited axle screw came apart on the second battery. Assumed it was a bad design like the TLR22 front wheel bolt that does the same thing till you have blue loc-tite'd it a few times (one isn't enough on either). I'll have to check this every battery pack I guess No kit is perfect and that screw is really short.
Anyone looking for .25mm shims, AvidRC offers a so-called clutch bearing shim set in a handy little container. AV-SHIM-525
Last edited by mes; 02-14-2014 at 11:52 PM.
#3515
Tech Rookie
#3516
Asking for some help and an explanation. I've ordered the aluminum hexes front and rear for my buggy. Will I need different front axles?
Blake
Blake
#3517
Tech Master
iTrader: (34)
#3518
Tech Elite
iTrader: (67)
http://www.amainhobbies.com/product_...ive-Film-Sheet
http://www.amainhobbies.com/product_...otective-Sheet
jconcepts is a good value, but the ae one just is thicker, its what i run on my b44.2, and have one ordered for my b5m *note ae is only one sheet
http://www.amainhobbies.com/product_...otective-Sheet
jconcepts is a good value, but the ae one just is thicker, its what i run on my b44.2, and have one ordered for my b5m *note ae is only one sheet
#3519
#3522