Inspire us. Show me your BEST, CLEANEST electronics installation pics.
#2178
My T4 (Just waiting for my Reedy motor) :
#2180
Tech Master
iTrader: (1)
#2183
Just did the wiring for my new LTX in time for Saturday practice Not the best looking wiring job but I think it is good enough
#2184
just curious, but is anyone familiar or have used plasti dip aerosol on their installs for blackening wires and components. its rubber paint and can be peeled off if needed. You can find black at the home depot.
my old car.. repost from pg. 92.
my old car.. repost from pg. 92.
Last edited by JKL1031; 12-29-2012 at 11:29 PM.
#2185
Tech Addict
iTrader: (2)
I did for my Orion PowerCaps:
I used the big can, to dope the stuff in. The spraycan gives a bubble effect to the Plastidip and looks really stupid. It also leaves a really thick layer, and the dope methode just dry's really even.
For the wires I think it peels of a bit to easy, cause it has a hard time sticking to silicon wires. What I did with plastidip is make sure my elec's are whaterproof :P
Regards Robert
I used the big can, to dope the stuff in. The spraycan gives a bubble effect to the Plastidip and looks really stupid. It also leaves a really thick layer, and the dope methode just dry's really even.
For the wires I think it peels of a bit to easy, cause it has a hard time sticking to silicon wires. What I did with plastidip is make sure my elec's are whaterproof :P
Regards Robert
#2186
Didnt know it wudnt stick to wires. Ive painted real car trim pieces without it bubbling unless mean the rough finish it has to it.