MGT Question

Reply Subscribe

Thread Tools

Search this Thread

07-13-2012 | 04:40 AM

LosiDriver2.0

Thread Starter

Tech Rookie

Joined: Mar 2012

Posts: 11

MGT Question

I am looking at getting a mgt 4.6. I have a hpi s-25 engine i wanna put in it. Is there anything different i would have to do?

Thanks

07-13-2012 | 08:51 AM

ntrain42

Tech Master

iTrader: (33)

Joined: Feb 2011

Posts: 1,980

Quote:

Originally Posted by LosiDriver2.0

I am looking at getting a mgt 4.6. I have a hpi s-25 engine i wanna put in it. Is there anything different i would have to do?

Thanks

I guess the question is why when there are much better choices out there. Are you just buying used and found a killer deal or have a specific budget for a new roller etc?

07-13-2012 | 10:27 AM

LosiDriver2.0

Thread Starter

Tech Rookie

Joined: Mar 2012

Posts: 11

Quote:

Originally Posted by ntrain42

I guess the question is why when there are much better choices out there. Are you just buying used and found a killer deal or have a specific budget for a new roller etc?

I found a killer deal

07-23-2012 | 07:50 AM

zmetal

Tech Apprentice

iTrader: (6)

Joined: Jun 2012

Posts: 74

From: Between the Bay and the Delta in CA

I have one and a GST and a Savage and the MGT is much easier to work on Variety is the spice of rc life

08-06-2012 | 03:07 AM

GT4Point6

Tech Initiate

iTrader: (2)

Joined: Dec 2011

Posts: 45

From: Ramona, Ca

Any .21 and up should fit with out issue. The original MGT was a .21, current is .28 or .50. I'm putting a ZR30X with a pull start in mine, same mounts.