After a few trial and errors, I went about 54mm on my x12 13.5 boost

Chris, what body is that?

What are the pros and cons of Yokomos front/rear shock setup compared to typical Link tubes which are all the rage?

Where can I get that Steering knuckle that's on Naoto's car and what Servo is he using?

Hey guys how should i treat my front tires with additive would it be front inner half or full treatment thanks,aaron

For all of those who haven't seen CRC's most recent sharp object prototype...



http://events.redrc.net/wp-content/g...arpercrc-4.jpg

Most treat the inside

Mountain of info HERE for the new to 12th scale racers

Dont know for sure, I did this one and an old Olds areo-tech body for a customer. It is an older body tho, back before the use of overspray film.

It varies from track to track, sometimes from heat to heat. Start with about 1/4 to 1/3 inside and add or subtract depending on how the car handles.

Thank you for awnsering

Also thanks to you for your awnser

Hey All,

What are you all running for servos?

Thanks

I've been running the Futaba S9650 for several yrs now, for me its a great blend of affordablity and performance. There are better/more expensive servos you can use.

Futaba 9650 or that JR I can never remember the number for are the best out there IMO. KO also makes a nice one but I have never used it so can't compare. Most everything else is junk.

Don't forget about the Savox SH-1357, once you have used it you will never look back.....