I just bought a new GTB2 esc with a ballistic 8.5t motor. Setup and install seemed to go without a hitch. It also bound to my controller just fine. However, it seems to lock up and not work. I got the error code of the blue and green lights staying on.

That would say it is a locked rotor detection. I have reset the esc several times and I am still coming back to this issue.

Please help. Thoughts?

I'm not familiar with the GTB2, but if it's like my Kinetic or Havoc Pro SC, there should be a hall sensor test function. Test the motor sensors and see if all three are working. It's been my experience that a sensorboard failure is usually the culprit. Good luck.

Please email [email protected] for assistance.

Whats up with Novaks stuff ?

They seem to have way too many sensor board issues....

If our techs determine that this is a sensor board problem, we can quickly send him a replacement board.

The issue was in fact a bad sensor board. Got it replaced, thanks to Chuck at Fastlane in Blue Springs, MO!

i think im having the same problem im glad i got the edge 2s just because novak is a good name brand ive already thrown away a reedy 8.5t and esc for the stater shorting and frying my esc no warranty or parts available for ether thats why i buy novak even if it wasn't under the warranty then at least i could buy the parts or use their trade in option