R/C Tech Forums - View Single Post - Advance R/C Car R10 2015
View Single Post
Old 07-02-2015, 08:21 PM
Tech Master
iTrader: (6)
Join Date: Feb 2014
Location: Kirkland, WA
Posts: 1,159
Trader Rating: 6 (100%+)

By bridge you mean the arm mount blocks? If so, I would try taking one of the 1mm shims out and replace it with a .5 and a .3mm shim to give it a little bit of play. Or you can go the sanding route and sand the end of the arm down a tad, might be some leftover moulding seam there.
Carnage9270 is offline