Thread: Mugen MTX-3
View Single Post
Old 05-05-2003, 03:29 PM
Tech Regular
Join Date: Dec 2002
Posts: 389

Way to go Guys!! Thanks for the input!!!
Jason, no, didn't get the pm but i did mess around with the needles. Sent them all the way in counting the turns. Main went in two so I backed it out to the same, seemed right. The low though was only out about half to 3/4 turn so I'm gonna send that out another half and see if the temp comes down a bit. I'll let you know. If you do know though exactly what the Factory says they are sending them out set at I'd appreciate it!!!!
hicheef is offline  
Reply With Quote