Hi Everyone,
I recently built 2 2016 XB4's for myself and a friend. They've been amazing but i'm struggling with setup.
Using the Hudy Universal Exclusive Set-Up System (1/10 Off-Road HUD108905) along with the Hudy set-up board and the Hudy 20mm Droop Gauges I set the ride height to exactly 20mm following the instructions in the setup manual (dropping the car).
I then set the camber and toe to 0 front and rear as a starting point on the setup system making sure to hold the car down onto the 20mm setup blocks while making my adjustments.
However, when I put the wheels back on the car I end up with positive camber! Usually about +2-+3. I must be doing something wrong but I'm not sure what?
Any help is greatly appreciated!