R/C Tech Forums - View Single Post - Throttle Servo Linkage - Is this correct ?
Old 05-12-2012, 01:09 PM
Tech Adept
Huleboer's Avatar
Join Date: Feb 2011
Location: Horsens, Denmark
Posts: 217

2mm!? Thats WAY too much!

When the servo is idle (when you're not pulling og pushing the throttle) the servo should push the carb all the way in, and then you set the engine idle with the idle screw.
Usually about .7mm gap.

And when on full throttle the carb should be fully opened.
Huleboer is offline