Originally Posted by
Cannonball Dan
Higher at the tyre side
I run the standard TA 05 R A? and D blocks with the Aluminium Rear Upright Hop Up. Can I get more toe in than that?
I went thru exactly what you went thru 3 weeks ago...you will need only 1 block...the XA block at the front of your rear tranmssion.
I have the same alum rear up right...0 degree, using the existing D block at the rear...only changed the front block from A to XA. That will gives you 3 degree.
Also...take off all the sway bar.....
After 2 weeks of testing...my car is quite good, just a little push at couple turns...might need to trim down the rear toe from -3 to -2.5, that will require a C block at the rear instead of D.