R/C Tech Forums - View Single Post - Sleeving a Sintered Rotor?
Thread
:
Sleeving a Sintered Rotor?
View Single Post
07-18-2007, 05:27 AM
#
1
SWTour
Tech Elite
iTrader: (
9
)
Join Date: Sep 2003
Location: Hot Mountains of S.E. Arizona
Posts: 3,014
Trader Rating
: 9 (100%
+
)
Sleeving a Sintered Rotor?
Brought this discussion up on another board after reading about some NEW rotors that the strentgh showed low on...
Quote:
How big of a sleeve can you get away with running over your sintered rotor to pull more magnetic strength w/o hitting the windings?
Reply
SWTour
View Public Profile
Visit SWTour's homepage!
Find More Posts by SWTour
View iTrader Profile