OK..I just bought a 12 scale ...RC12L3 and just finish putting it together!! very nice car!! but..I have a few problems!!
1st. the kit give me 2 pairs of 10degrees front upper arm mount?? one set is bigger than the other set. and one seem to have more angele on it (small one) which one should I use?? (I install the small one instead)
2nd. It seem like I have to cut off the shock ball cup....to have the shock extend and work properly. This part was not explain in the manuel....I hope I did it right.
3. I try to fit my P2K2 stock motor in it. It fit ok ..and all but I can't use stock gearing. 75pionon w/26pinion. Because the motor placement was really close to the gear. What can I do?? Help.
Thanks