R/C Tech Forums - View Single Post - New CRC F1 At IIC
View Single Post
Old 02-19-2015, 08:22 PM
Tech Champion
iTrader: (17)
liljohn1064's Avatar
Join Date: Sep 2008
Location: Deerfield, WI
Posts: 5,909
Trader Rating: 17 (100%+)

I ran home and put the steering limiter mod on the car. I used 2 x 5 mm spacers and 15mm screws to replace the back screw on each side of the carbon lower arm. The steering arm hits the limiter about the same time the shaft of the pivot ball touches the knuckle at full throw. The screws come out a half millimeter more than the stock setup. The head of screw just comes up over the top of the arm on the limiter with plenty of clearance. Very nice solution and big thanks to the mind that thought it up!
liljohn1064 is offline