Originally posted by momotalo
opsss, sorry , that not what i ask about
front susp holder , the left one has a cavity for alu nut
but the right there was no cavity for alu nut
only the plastic. right
that the problem make the wider of the front arm not the same.
are every one has the same like that?
sorry if my question make you confuse......
my english not good enough
Yes, you are correct. All T1FK until the last batch (new blue box) has this matter. The one without the aluminum is 0.3mm shorter/flatter for hinge pin hole height when you put them with the alum insert one side by side on the glass table. But when you screw down (depending on how tight you ussually conviniece with), you may need 0.4 to 0.5mm spacer in between the bulkhead and that all plastic suspension holder.
Neil, thanks for bats position advice.