R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 11-29-2011 | 11:12 PM
  #7959  
Ryno B4.1
Registered User
iTrader: (4)
 
Joined: Feb 2011
Posts: 411
From: Mesa, AZ
Default
Originally Posted by xtraman122
I had the same issue, even the Ae nut driver wouldn't quite cut it. I ended up taking a Dynamite nut driver and grinding the OD down a little bit to get it to fit better.
I had the same issue as well. I spoke with Dave at DE and he is aware of the issue and trying to come up with a solution. I found that the AE 11/32 driver was tight but did work
Ryno B4.1 is offline  
Reply