Originally Posted by
DanDan
Hi iZzy,
I have tried the double joint bones today but found it is rubbing the c hub with close to full lock. The special bearing come with the bones kit in use but still rubbing it.
Do you guys just shave the c-hub to enlarge the space, or have I done something wrong?
Hi !
You have to cut some Material from the inner C-Hub, but this is maximum 1mm (only on the inner side where the CVD ends) . Serpent made the Double-Joint CVDs bigger then the prototypes to make them more durable
As i know, they "edited" the plastic forms for the future about 0,5-1mm - so its only a temporary step with a dremel