R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 11-17-2011 | 12:10 PM
  #7537  
T-BirdJunkie's Avatar
T-BirdJunkie
Tech Elite
iTrader: (10)
 
Joined: Nov 2004
Posts: 2,974
From: Norwood, OH...and CCRCR and The OhioRCFactory
Default
Originally Posted by Matt Trimmings
Something else to remember...the hex is able to withstand greater load than a small pin. If you use the hardened solid wheel pin you should be fine but I am sure some of you out there have snapped an axle pin in the past.
But there's still a pin driving the hex...soo...not sure how this translates into more durable? Maybe somebody can explain?

ThunderbirdJunkie snapped an MIP CVD back in the day on his B2. Still not sure what happened there Still never broken an axle pin, though. Only time the pin got stripped out was using JConcepts wheels, at least for ThunderbirdJunkie.
T-BirdJunkie is offline  
Reply