Originally Posted by
Mr.juarez
thanks guys.
so far i spent 4 hours taking my time and i did the shocks, diffs, bulkheads and the axles and ca'd glue the chassis, towers and top plate.
now no matter what i freaking do one of the axle is binding badly. no set screw just the pin in it seems as its getting stuck and it does not spin freely. the other 3 do, but this one stays at one position and it wont budge
im thinking defective pin or cva axle?
Had same problem with one of my kits! One axle was machined too little so the cup joint didn't go in enough and scubbed on the inside wall. They just have to give you a new axle (the part that come the bearings on).
Regards, L