Originally Posted by
khshapiro
after building and using the chassis brace that bolts into the bulk heads, i decided i didnt like it, there was still to much flexing for me . So i made this one that connected the front and rear diff. And now no flexing of the drive line. The hardest thing, if you could even consider it hard was finding 50mm threads and cutting it to fit. that part took the longest .... start to finish 5min. ive been running it for a little while now and still , no flexing, i think its a great mod for anyone not using the exotek chassis , and honestly i think i am going to make one and carry it over to my race truck using the exotek...here are a few pics
all this from a hotel room!
Not to be rude or anything, but that is way overkill. The standard hole above motor/replace front underbodymount - I have tried, tested, bashed, and literally put the truck on the ground with no bumpers, and stood it on end, then began to lean my body into the truck. Only after I was almost entirely being held up by my truck did the brace crack the Carbon rod.
My chassis Brace All the while, No flex.