R/C Tech Forums - View Single Post - binding an lrp sxx
Thread: binding an lrp sxx
View Single Post
Old 11-16-2011 | 08:01 AM
  #2  
MarkA's Avatar
MarkA
Tech Champion
iTrader: (21)
 
Joined: Aug 2001
Posts: 9,161
From: Corvallis, OR
Default
Originally Posted by asc6000
hey I just picked up a used lrpsxxcompetition that I beleive is working (based on the whole package I bought) that I cannot get to bind.
Following the lrp instructions I turn on the trans then the esc, then push and hold the set button for 3 seconds and the blue light is supposed to flash but it doesn't. I tried a bunch of times but no luck.
I checked the usual stuff inc a new sensor cable.
mt4 that works fine
Any tips?
If LRP's stuff doesn't go into set mode, that usually means it is not getting a signal out of your RX.

Does your servo work?
Is the LRP's plug to the RX correct?
Does any other ESC work with that TX/RX?
MarkA is offline  
Reply