Originally Posted by
Pattojnr
heat shrink only Matt. maybe ok for Stock. i have Major doubts for my 3.5T
i have just taken one apart cause it didnt feel smooth, then when i re shrinked it, i double shrinked wiht some super glue between the first and second layer where the pins are. so will see how they hold up. the insert for the shaft where the pin goes through, is solid, only hole is for the pin. so not even a chance to put a grub screw in.
Last Sunday i was on carpet with mod class.
I used double joint cvd and no matters with them. I know you're disappointed about that problem, but take a look at other brand DJCVD and can see that a lot of them use heat shrink only. I don't think it is a mistake build them like that, there are some advantages reagarding their moovement and vibrations, maybe yours had a bad heat shrink.
Try to replace it and reuse like that.
Bye