Originally Posted by LumberJack

Hello!

My esc is mounted in a 1/10or-car. When I stop the car, release the throttle the engine will not start again, the car will not go forward. But a small (barely noticeable) boost from another car and it will start again.

Have tried this without pinong, the same. When I turn very lightly on the pin it go again.

Have tried different sensorcables, and diffrent engines. Have change capicator also.

Before i had the esc in a 1/12 pancar, then i put it in my OR, drived about 10 rounds then this problem apperead.

Broken or Software? Or something else strange?