R/C Tech Forums - View Single Post - Serpent S411
Thread: Serpent S411
View Single Post
Old 11-09-2011, 01:49 PM
  #1689  
Jinjiro7
Tech Apprentice
 
Jinjiro7's Avatar
 
Join Date: Mar 2007
Location: Oshawa, ON, Canada
Posts: 57
Default
+1 I did the same thing. Also additional slop for me was the ID of the small bearing that's on the steering bridge was too large. So I put a little CA glue on the thread of the screw to thicken it up...



Originally Posted by BAD007SUZUKI
HERE IS WHAT I DID. I USED A LITTLE LOCKTIGHT ON THE TOP SCREWS.

3MM COUNTERSINK WASHERS

Jinjiro7 is offline  
Reply