R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 11-07-2011 | 08:45 PM
  #10415  
Cameron Kellogg's Avatar
Cameron Kellogg
Tech Champion
iTrader: (45)
 
Joined: Nov 2007
Posts: 5,776
From: Idaho
Default

Originally Posted by MantisWorx
Strange, the track i ran on the video was high bite and smooth and no pinned sucked in my opinion!! i had no problem getting out of turns. interesting how everyone is getting away from pinned in less than a week! LOL
The track you ran on was way more open than my track.

Here is the A-main of round 1 of the Rockstar Short Course Series. We have a spec tire of the AKA Rebar's (first time running on them). I got to the track 15min before qualifying started so I did not get any dial in time besides my two qual runs. I decided to try the pin mod again in the main (this video) with a 20t front pulley. I had be running the MTK slipper with 19t front pulley. Rebars seem to slide around to me off power but everyone has to run them so I will get dialed in by the next round. The Losi truck that TQ'd is a factory driver and is I always on his game so I was not going beat him showing up late. We where the only trucks to turn 19 laps and run 15.9 lap times. I lost about 8 seconds on a turn marshal (lower left off camera) and another truck jumping the track that pretty much decided that I was not going to put together a good run to keep up with the Losi. Still always fun and always learning more of what I like and don't like.

+ YouTube Video
ERROR: If you can see this, then YouTube is down or you don't have Flash installed.


I am the orange and white truck qualified 2nd.
Cameron Kellogg is offline