R/C Tech Forums - View Single Post - Hobbywing ESC Settings ONLY
Thread: Hobbywing ESC Settings ONLY
View Single Post
Old 11-05-2011 | 12:51 AM
  #160  
Mb3195
Tech Regular
 
Joined: Apr 2011
Posts: 421
Default
Originally Posted by mavrick2k5
hi all has anyone got a setup for the following

Teams powers 13.5T copper can motor
24 meter lenght track indoor

software on esc v3.0_110930 stock
setup so far

MOTOR: Teams powers 13.5T copper can
FDR: 6.9 on 64dp
F/W: 930
MOTOR TEMPS: 165F
RUNNING MODE: FORWARD/BRAKE
DRAG BRAKE: 5%
VOLTAGE PROTECT: 3.0v
DDRS: LEVEL 9
BRAKE FORCE: 100%
REVERSE FORCE: 100%
INITIAL BRAKE: Drag Brake
NEUTRAL RANGE: 6%
BOOST TIMING: 64
TURBO SLOPE: 18 UNITS/0.1 SEC
OVERHEAT PROTECT: ON
TURBO TIMING: 0
BOOST START RPM: 5000 RPM
TURBO DELAY: OFF
TIMING ACC/SLOPE: 500 RPM/UNIT

I can only about 0.5 sec of each lap of the leaders, i went round the track with them while racing and noticed that they get good pull of after slow corners.

Any help would be great thanks and good racing.
Try the settings I just posted for the orca motor below. Your timing acc, start rpm and fdr are killing you out of the corners.

Make sure you check your temps!
Mb3195 is offline  
Reply