Originally Posted by
Maxxingout
The inner toe block on the rear has a protruding diameter that goes into the plastic diff. The diff has a round counter bore that the toe block nub inserts into. Then you run the screw thru to hold it all together.
If I have the wrong inserts for the toe block, does that mean the setup sheet that came with this buggy is wrong? I have not built to many kits in my life so I apologize.
0,1,2,3 are for the front end , 4,5,6 are for the rear end. The front ones will be loose in the blocks if you use them in the rear. They are slightly smaller than the rear ones.