Originally Posted by
dms888
got my receiver pack today and tried it with the esc and d3 17.5. first time the 1&2 6&7 didn't blink and when i pushed the throttle there was a buzzing sound like the motor was trying to work but it wasn't. cut it off and when i plugged it all back up the 1&2 6&7 lights are blinking. flashed the esc and reset everything. still same thing, i have tried everything and went over everything and cant figure this out. this is a brand new motor never run, could it be the problem and not the esc?
try the esc with a 2s see if that changes,try a different motor,use the on board sensor checker to check the sensor.there are things you need to do before it will need service