R/C Tech Forums - View Single Post - HPI MT 1 ¾ with OS 18 TZ VERY FAST!
View Single Post
Old 11-01-2011, 07:47 AM
  #1  
46u
Tech Regular
iTrader: (4)
 
46u's Avatar
 
Join Date: Oct 2006
Location: Macon, Georgia
Posts: 334
Trader Rating: 4 (100%+)
Default HPI MT 1 ¾ with OS 18 TZ VERY FAST!

Stared out as a MT Racer, which came as a kit. I up dated to MT 2 specifications other then the chassis upper deck and radio box. It has many up grades including an OS .18 TZ which has about a gallon or less on it with the recommended OS speed T-1040 R70 exhaust pipe which has as much HP as some big blocks and is crazy fast. All so has OS dual stage air filter, alloy rear diff housing as the plastic one would not hold up with the TZ, 100cc fuel tank stock was 75cc, HPI Savage heavy duty race vented clutch bell with ball bearings, fiber brake disc, HPI exhaust header, HPI front and rear universal dog bones (CVDs), alloy front wheel hubs, all tie rods are titanium, fuel filter, HPI heavy duty alloy engine mounts, used red body fairly beat up, new clear body, on off switch that has charging jack and Proline bowtie tires. Comes with steering and throttle brake servo but no RX or RX battery pack. I all ways put after run oil it when done running.

Asking $230 including shipping to the lower 48 states. Will consider any reasonable offer.







46u is offline