Originally Posted by
beaven
ran mine on the track this week there was a clicking noise under hard acceleration. i found the clicker was loose but that wasn't it so i checked the rear diff,there was very little lube in it so i corrected that. i also took out the 550 4000kv tenshock motor and put in a castle 4 pole 3800 540 motor as it felt overpowered. it was better but the noise came back. the belt tension feels good,any ideas? i have the basket set-up in the truck and other than the noise it runs fine......thanks
slipper is probably too tight and belts . i run with the over drive clicker up front
make sure that all your transmission case screws are not over tightened . if they are it will bind and make noise you might think that it is the belts . it happened to me once.