I know I asked this a page back or so, but could you suggest a good starting point for the following set up:

Yokomo B-max4 II (87 spur puts final drive ratio very close to b44 with 81t spur)
Speedpassion V3 6.5 turn
Speedpassion lpf 2.0 with 323 firmware

I had an older Orion 7.5 in this recently geared 18/87 and it just didn't seem to have any "snap" or top end to it. I went from no boost up to 20* and even added 10* turbo on it to see if that would wake it up. Local track has a double right out of a slow 180 and most of the 4wd's clear it fairly easily. I was having to be very precise to make it clean. As I mentioned the motor is a couple years old so I ordered the SP 6.5 today and just want a good starting point on both gearing and speedo setup if possible.