Originally Posted by
Ogzer707
After replacing my old combo with the new xerun sensored combo 150a esc and 4274sd motor I really can't tell much of a difference. What's going on.
I have e-revo 68/17 gearing. 2 2s turnigy 30c 5000mah. I'm about to have pro line 40 series big joes tomorrow. Is my gearing way off or something? When I full throttle it barely lifts off ground and I have punch to 6. I think 75% reverse. Everything else default.
And on another note. Why do I lose sensored on my setup as soon as I full trottle. I get two flashing lihts red/green same time. Do I have a bad set or are my settings wrong? It was a new set from hoobypartz
It switches to sensorless because sensorless is more efficient, It uses less power to run sensorless and a sensor is not needed at full speed.