R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-28-2011, 05:01 PM
  #6992  
Ryno B4.1
Registered User
iTrader: (4)
 
Join Date: Feb 2011
Location: Mesa, AZ
Posts: 411
Trader Rating: 4 (100%+)
Default
Originally Posted by Oso Negro
This is too funny! I just found some old ones in one of my parts bags last night and tried them on the rear hubs. They fit just fine! Visually they look really close in size, if not the same, to the AE plastic hexes.

I ran it on the track today at lunch time and had no problem, either.

I'm going to compare them with my digital calipers tonight and get an exact number.
I ordered a similar set from Kyosho and the hole was too small so I assume the hole will be too small on these also
Ryno B4.1 is offline  
Reply