Originally Posted by
idrummerboy13
i cant figure out how to put the front hexes on the car, i have the front axles, the actual hexes and sc10 steering hex block(w.e it told me to get to make the conversion work on amain) it seems the front axle is thicker than stock, i couldnt figure how the hell to put it together, the rear i got fine tho
Did you get the axle for B4 and not the SC10? Take the axle and slip a bearing on the axle and slide it all the way on. Clip the C clip on the axle and then slide the assembly into the hub. Slip the other bearing on the outer bearing position. Slide on one shim and then the axle pin. Finally slide on te thin hex and that is it.