hi all has anyone got a setup for the following
Teams powers 13.5T copper can motor
24 meter lenght track indoor
software on esc v3.0_110930 stock
setup so far
MOTOR: Teams powers 13.5T copper can
FDR: 6.9 on 64dp
F/W: 930
MOTOR TEMPS: 165F
RUNNING MODE: FORWARD/BRAKE
DRAG BRAKE: 5%
VOLTAGE PROTECT: 3.0v
DDRS: LEVEL 9
BRAKE FORCE: 100%
REVERSE FORCE: 100%
INITIAL BRAKE: Drag Brake
NEUTRAL RANGE: 6%
BOOST TIMING: 64
TURBO SLOPE: 18 UNITS/0.1 SEC
OVERHEAT PROTECT: ON
TURBO TIMING: 0
BOOST START RPM: 5000 RPM
TURBO DELAY: OFF
TIMING ACC/SLOPE: 500 RPM/UNIT
I can only about 0.5 sec of each lap of the leaders, i went round the track with them while racing and noticed that they get good pull of after slow corners.
Any help would be great thanks and good racing.