Originally Posted by
Glowster21
Finally got mine all done, anyone have any issues with binding in either of the rear axle joints? I'm getting a clicking out of one side, and the height of the arm actually changes if you slowly rotate that side, almost like axle cup is bent. Haven't pulled it apart to try a different set of holes yet but wanted to check to see if anyone else had problems?
I did and fixed it myself. The ball end of the CVD hits all the holes in the axle that the pin slips into. Like they all have high spots.
You will see pull the pin and pudh the cvd into the axle you have to push it in,it binds.
I just put my cvd in a drill took some 1000 sandpaper and removed alittle material from the ball. Problem solved. Also you can chuck the axle in the drill and clean up the ID of the axle where the cvd goes in.
Pete