Update on the pin mod:
Well the rain cleared up and left my track perfect to run. The power is now where I like it. On asphalt I can lift the front end when I punch it. So after a couple laps I started to feel decrease power again and brought it in. Either the slipper nut backed out (which I doubt) or I didn't have the slipper plate all the way back after reinstalling it. So I tighten it down again and all the power was back. Finished a couple packs and on the last pack the power was gone again. Checked the slipper nut and it was tight where I left it. Now I'm starting to think maybe the pads are no good anymore. How can I tell if they are gone. They are real slick on both sides across the whole pad. I pulled out the stock pads and they have a gritty feeling to them. I have installed those but it got dark and I didn't get to try it. What else can I be doing wrong. I am totally sold on the mod but very frustrating. Anyone have any other ideas. I posted this on a local forum as well and most replied back with there stock pads and no mods/washers to be working fine. I am lost now. Anyone?

Terry