R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-25-2011 | 04:07 PM
  #6876  
916bdogg's Avatar
916bdogg
Tech Regular
 
Joined: Mar 2011
Posts: 272
From: Sacramento,CA USA
Default

Originally Posted by bilster44
Here is a setup that one can enjoy, and drive the piss out of with confidence.

Front: #2 pistons, 2 limiters, Kyosho bright orange springs, 30wt oil, inside on the tower, outside on the arm. 1mm camber washer, and inside on the tower, and inside on the 3 hole caster block. 24.5mm ride height.



Rear: #2 pistons, 2 limiters, Kyosho bright yellow springs, 27.5 oil, inside on the tower, and inside on the arm. 1 washer under the u-brace ball stud located on the inside hole of the u-brace. B hole on the "A" plastic insert of the aluminum 0 degree hubs. 3 degree toe block with "1" degree of anti squat. 24.5mm ride height. Thick battery pad in the front, and a thin one in the rear. Of course, all the weights in the usual places too. I honestly feel the key to this set up is the K springs...car stays so flat in the corners, and jumps like a dream.
Personally Seen this Car and it Hauls A** , Don't be ashamed to try it , 2 limiters . I been running really close to this but with AE BROWN'S/GREENS .With +8 Bright Yellow Rears And Mustard Colored Front K' Springs!

Bilster's car is on Rails Hands Down !*
916bdogg is offline