R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-24-2011 | 04:41 PM
  #6830  
YankeeFan123's Avatar
YankeeFan123
Tech Elite
iTrader: (73)
 
Joined: Jun 2010
Posts: 3,218
From: San Diego, California
Default

Originally Posted by bilster44
Here is a setup that one can enjoy, and drive the piss out of with confidence.

Front: #2 pistons, 2 limiters, Kyosho bright orange springs, 30wt oil, inside on the tower, outside on the arm. 1mm camber washer, and inside on the tower, and inside on the 3 hole caster block. 24.5mm ride height.



Rear: #2 pistons, 2 limiters, Kyosho bright yellow springs, 27.5 oil, inside on the tower, and inside on the arm. 1 washer under the u-brace ball stud located on the inside hole of the u-brace. B hole on the "A" plastic insert of the aluminum 0 degree hubs. 3 degree toe block with "1" degree of anti squat. 24.5mm ride height. Thick battery pad in the front, and a thin one in the rear. Of course, all the weights in the usual places too. I honestly feel the key to this set up is the K springs...car stays so flat in the corners, and jumps like a dream.
What kind of track would this set up be the best for? I run on a hard packed damp, high traction indoor track. Would the springs listed above help more or less if right now I'm running associated brown in front and associated green in rear?
YankeeFan123 is offline