Originally Posted by
bilster44
Here is a setup that one can enjoy, and drive the piss out of with confidence.
Front: #2 pistons, 2 limiters, Kyosho bright orange springs, 30wt oil, inside on the tower, outside on the arm. 1mm camber washer, and inside on the tower, and inside on the 3 hole caster block. 24.5mm ride height.
Rear: #2 pistons, 2 limiters, Kyosho bright yellow springs, 27.5 oil, inside on the tower, and inside on the arm. 1 washer under the u-brace ball stud located on the inside hole of the u-brace. B hole on the "A" plastic insert of the aluminum 0 degree hubs. 3 degree toe block with "1" degree of anti squat. 24.5mm ride height. Thick battery pad in the front, and a thin one in the rear. Of course, all the weights in the usual places too. I honestly feel the key to this set up is the K springs...car stays so flat in the corners, and jumps like a dream.

I agree that this is a very good setup for the B4, Long or Standard chassis. I've been running essentially the same thing with exception of 25* castor blocks an 25 wgt oil in back and out one hole on the rear tower. I've run this setup with both chassis configurations and have found it to be the best.