R/C Tech Forums - View Single Post - Com Lathe power
Thread: Com Lathe power
View Single Post
Old 10-20-2011 | 11:11 AM
  #3  
Brit_racer's Avatar
Brit_racer
Tech Elite
iTrader: (210)
 
Joined: Oct 2011
Posts: 3,380
From: MidWest USA
Default
The ice would be one option. Trouble is i would have to buy a power supply as well because i think the ICE is 12v?
Now i am looking at $80? That is getting close a a brush-less set up.

Are there any old or new AC/DC chargers that have this motor run in feature? It does not have to be LIPO or even NImH as i already have a Lipo charger.
Brit_racer is offline  
Reply