R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 10-19-2011 | 03:58 PM
  #6731  
DirtRacer68's Avatar
DirtRacer68
Tech Master
iTrader: (16)
 
Joined: Sep 2003
Posts: 1,097
From: Pa
Default
Originally Posted by bilster44
Do you have a lot of top shaft threads showing outside of the slipper nut already?
I tried to set it like the directions 0.5mm of thread sticking out but that didn't work so I tightened to where there was alot showing but it still wouldn't work.
DirtRacer68 is offline  
Reply