Originally Posted by
Solara
You might be running the sensorless mode....there should NOT be any light when you are in neutral position. Check your sensor wire and all the connection.
Originally Posted by
John Pape
Sounds like it gone into sensorless mode, try changing the sensor wire, failing that unfortunately, your gonna have to change the sensor in the motor.
Just got done inspecting the sensor wire and made sure it was plugged in properly (pulled it out and back in again). Tested it again and also recalibrated my TX with the ESC. Lifting my SCT off the ground, pulled the trigger slowly to FULL and then applied the brakes....no green LED flashing in the neutral position. Did it again but a little quicker, halfway thru the full throttle position the motor/ESC cogged down and jumped back on power and got the LED flashing at neutral again. This also happened with my SCT placed on the ground.
With that said, has the sensor wire gone bad? Will try again with another new sensor wire if that will fix it and if not I'll look into the sensor board which I hope won't need replacing.