Originally Posted by
jpure009
Is AE coming out with the 2nd pic of the Top shaft with pin hole & inner slipper hub, with the indent for the pin.....That 2nd picture, looks like it mite solve all the problems, people are having....NICE JOB!!!
I said this before, i bought 2packs of Slipper Hardware, and used the thrust washer that was machined the widest...The widest was .27mm wider then the smallest of the 3 thrust washers i have.....So with that and HD pads in&out it worked well for me. I'm hoping the RCSHOX Dual slipper will make it even better!!....I can still use alil more burst from the slipper on the CLAY track i run on....
In the 3rd pic, what is the a-arm on the RIGHT bent???
thx
All credit to the fastpede! Not sure if AE will make this or not. Heck I'm not sure if I'll like it or not. I guess if I don't I'll take the pin out and go back to normal.
I'm using the rcshox pads and haven't had any problems, haven't noticed any fade and haven't sanded them at all. Probably 5-6 race days or nights on them so far. They work well and are much better than the Ft pads.
Both of those arms are bent, pretty badly. The pic makes it hard to tell whats what. The front edge of the arms are pretty straight. The back edge is where all the bend is. I think the bend is equivalent to adding castor?