Originally Posted by
jdeadman
Hey all you 1/12 gurus, I am modding my old GenX cause I can to have the steering setup similar to the genXL where the steering links mount inside on the servo saver and I am just playing with angles of the links now
What is the best angle for the links to be at (at center) for the best steering.
This is what I have currently after mounting the Servo in it's new location.
I can move the servo for and aft. I can get close to parallel if I need to but just looking for a good starting point and also what do different angles do.
the Servo is mounted on the angles mounts.
I always have my steering rods slightly forward when using the servo angled holders. The tie rods are behind the servo saver and the rods when looking down at the servo saver are again slightly ahead
With the servo in centered position you could provide side shot picture of the links so I can see what angle your rods are at