Originally Posted by
madac
Do you still have good compression? I think it looks pretty even before you cleaned it up. Looks clean and the browning on the button and the head of the piston look like it ran pretty clean. But if it has lost compression the sleeve would need to be resized or replaced along with the piston but I think from the pictures it looks really good before and after.
Thank you for the feedback, it does have good compression, I Am bit concerned as side of pistion is turning some what grey.
Can you also advise what is recommended way of cleaning engine form inside, once I used Loozen which is some what like WD 40 it may have removed some of the coating off it?
Do I just use water and laundry detergent to clean it with water then use air to clean and install back using after run oil? Thanks