R/C Tech Forums - View Single Post - Setting better end points on servo
Thread: Setting better end points on servo
View Single Post
Old 10-06-2011 | 04:51 PM
  #5  
RustyOne
Tech Addict
iTrader: (26)
 
Joined: Jan 2010
Posts: 545
From: South Australia
Default
Originally Posted by TedMosby
Yes adding throw is one of the options in the software. It will let you go as far as just under 180 degrees on some servos IIRC. All this is assuming of course that the servo in question is a Hitec digital programmable.
Can you point out which part of the programing can i make that change.
RustyOne is offline  
Reply