Originally Posted by WideOpenThrottle RC

Picked up a FTSC10 yesterday to run on shortcourse nights at the local track. I've built several kits and pay close attention to the details but I've ran into a issue I just can't figure out. When bolting the transmission case halves together the 3 1" long screws which pass through it which thread to the motor mount plate don't seem to be long enough? With the washers over them I can barely get a thread in the motor mount plate and by taking them off I'm still not flush with the blue plate? Tranny spins free and I can't see a gap or anything which leads me to believe nothing is installed incorrectly. Any help on this would be great. Thanks