R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 10-05-2011 | 03:52 AM
  #8113  
Jstall7543's Avatar
Jstall7543
Tech Elite
iTrader: (2)
 
Joined: Jul 2009
Posts: 3,106
From: Down Town Olympia
Default
Originally Posted by jpure009
Went to the track today, SC10 4x4 was fantastic, except..

I had my Sub-trim at 30L, which was a lil too much but could deal with it...

By the end of the day, i had to be 90L sub-trim to go straight...

Got home and looked at the servo, the screw going into the servo horn at the top(which i forgot to put locktight on), looks like it has backed out & is bent, I THINK???? It backed out just enough that the servo still had free range of motion, but anymore and it would cause binding while steering.

Could i have bent the MG at the top(outside) of the servo???

Taking apart 2morow..



THx
If your using a plastic horn then the servo should be ok, usually the plastic horn will strip out first. Only one way to find out, it's not that bad to tear down. Always loc tight the horn screw, on every servo and never have a problem. Just use a tiny tiny bit.
Jstall7543 is offline  
Reply