[QUOTE=silverhkswrx;9733654][QUOTE=JCarr;9723746]Body Specifications:
Any "SCALE" molded wings can be used. Lexan wings 10mm maximum height / side dam height
can you please clarify this rule?
Tamiya bodies have the raisers that are higher than 10mm, but the wing itself is the same size/dimension as any lexan wing out.
Is it the height of the wing itself, the risers, or combination of all?
The actual "Lexan" part of the wing or wing cord can not be larger then 10mm at its thickest point....you could have 5ft tall risers if you wanted to they are not the issue. Tamiya lexan racing wings cut to just about the standard trim line are right at 10mm.
This rule is in place to stop people from using standard TC or Protorform type wings on their cars. Also some of the HPI bodies do come with lexan wings that are well over the 10mm rule and they need to be cut down to be Fully USGT legal....or just run one of the many hard plastic scale looking wings.