Ok, I have strange problem. rs pro problem, I am running 212. Now after I put my esc into my SCR I have blinking 1,2 +6,7 which by the trouble shooting table is motor settings incorrect. But the problem is my motor setting is set for 1 (brushless, brake, no reverse) (verified in hotwire) I have tried a couple different sensor cables and 2 different motors and same outcome. Is this a send back to tekin or is there a way to make it happy again? Tried resetting factory settings didn't work. Unless someone has some input this is going back to tekin
Last edited by rx7ttlm; 09-29-2011 at 10:17 PM.